Steps:-
1) Open the ORCAD Capture SIS – Lite .
2) Click on
“ File “ and new>project .
3) Give a name and click “OK” .
4) Then Select “Create Blank Project” and click on
“OK”.
5) Then take the required components from “pspice
components” under “place” at top .
6) Connect the components with wire .
7) Make a new “New Simulation Profile” under “PSpice” .
8) Give the necessary values.
9) Place probs on proper locations / node .
10)Run , and verify the output.
The video link for RC Coupled Amplifier in Orcad -- Click Here
No comments:
Post a Comment